Printing TPU with the Monoprice Maker Ultimate 2
This has been a real challenge for me. Being a direct drive extruder you would expect it to handle TPU really well but that is just not the case. There are some flaws in the … Read more
Mike
How to Break In a New Clutch
There is a lot of misinformation out there on this subject. The reason for this is because the clutch and how it is wearing is not an easy thing to inspect. You have to go … Read more
Quick and Dirty Clutch Break-In Comparison
I highly recommend you go to my other post about clutch break-in. It goes into more detail than I do here about proper break-in procedures. When I say how long a clutch will last below … Read more