This is a gauge mount designed to fit in a stock 92-95 Honda Civic EG Hatchback cup holder. I wanted to maintain the use of the stock holder on the drivers side while also having a gauge in the right hand side. It is at an angle of 40 degrees and can be seen by the driver clearly. It should fit any 52mm gauge out there that uses a standard gauge mount.
The way it works best is you run your wires up through the cup holder and then the gauge pod then plug them into your gauge. If your wires are not long enough then you can plug the gauge in afterwards but it is tight. Decide how you are going to plug it in then put the gauge into the pod the secure it in place with the normal metal hardware. Put the gauge pod into the cup holder and secure it with the locking ring by spinning it tight.
There are plenty of good wires to tap into at your radio for gauges so don’t worry. The only one you may or may not find there is a headlight wire. I had to get to that from the fuse box on the drivers side.
Prices
Black/Grey PLA: $25 + Shipping
Color of choice: Contact for quote and colors in stock. Material can also be selected if desired. PLA is cheaper, PETG is more expensive. PETG is more heat resistant and if you are in a hotter climate this is the way to go.
Please contact [email protected] for a shipping quote on any purchase.
